Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterOlympia Chimney Chimney Repair in Newark: What to Know First
We repair Olympia Chimney products in Newark every week, and most jobs are done in a single visit. Expect honest pricing before we touch anything: a typical Olympia Chimney repair runs $225 to $900 depending on what failed, and we tell you the number on the phone before the truck rolls. If the chimney doesn’t need the work, Wendell will say so first.
This page is for Newark homeowners who own an Olympia Chimney product, whether it’s a stainless liner, a chimney cap, or flashing components tied to an Olympia install. You want someone who knows how Olympia parts behave after a few Newark winters, not a crew guessing at it. Call (848) 331-2638 and you’ll get a live person, probably Wendell himself.
How Olympia Chimney Products Fail - and How We Fix Them
Olympia Chimney makes solid products, but every brand has patterns. Here’s what we see on Newark roofs and what we do about it.
- Olympia stainless steel liners pulling at the seams. The liner isn’t failing on its own. In Newark’s freeze-thaw cycle, the masonry around the liner expands and contracts, and over time the liner’s connection points work loose. We see this most on Olympia’s flexible stainless liners running through uninsulated exterior chimneys. Fix: we resecure the liner at the top plate and check the entire run with a camera before calling it done.
- Corrosion at the Olympia cap base where it meets the flue tile. This is the weak point on nearly every Olympia cap we service in Newark. Rain sits in that seam, then winter freezes it, and the expansion pries the cap loose or starts rust where the stainless meets the mortar. Fix: remove the cap, clean the seat, reset it with proper fasteners, and seal the joint with a high-bond chimney sealant. We do not caulk over rot and call it fixed.
- Olympia flashing kits failing early on brick chimneys. Most Olympia flashing is fine, but the counter-flashing step is where shortcut installs go wrong. We see gaps where the flashing should be cut into the mortar joint, and water gets behind it. Fix: cut a proper reglet into the mortar, install the counter-flashing the way it should have been done, and confirm with a water test.
- Spalling brick around Olympia chase covers on prefab units. A chase cover keeps water out of a prefab chimney chase, but when the cover seal degrades, water works into the wood framing and the brick veneer on the chase starts popping. We see this a lot in Newark’s older neighborhoods where prefab fireplaces were added to existing homes. Fix: replace the chase cover, repair the spalled brick, and reseal the entire top of the chase.
- Leaking at the storm collar on Olympia rigid liners. The storm collar is a simple part that gets ignored until water stains show up on the ceiling. The collar slides down over time, or the sealant was never replaced after year three. Fix: reset the storm collar, re-seal it, and check the flashing below while we’re up there. This is a $150-ish repair that prevents a $2,000 ceiling fix.
Our Olympia Chimney Chimney Repair Process
Here’s how a repair goes, from the first call to the final look-over.
- 1
You call, a live person answers. We ask what you’re seeing, what kind of chimney you have, and when you first noticed the problem. That’s when we give you a ballpark number.
- 2
We arrive with a real window. The sweep who shows up is background-checked, in uniform, and knows Olympia Chimney products by sight. Wendell or one of his crew will walk the roof and the firebox with you if you want.
- 3
Camera inspection, every time. We run a camera up the flue and show you the footage on the spot. You see what we see. No verdict without pictures.
- 4
Parts decision: OEM vs. aftermarket, and why. For Olympia caps and liners, we use OEM when it matters and quality aftermarket when it doesn’t. We tell you the difference and the cost of each before you decide. No surprises at the invoice.
- 5
The repair, done clean. We fix the problem, not just the symptom. Mortar repointing, flashing reset, cap replacement, whatever it is. Drop cloths go down before any tool comes out.
- 6
The test and the guarantee. We run the camera again, show you the finished work, and hand you the 90-Day Done Right Promise in writing. If it’s not right, one call brings us back. No charge.
What Olympia Chimney Chimney Repair Costs in Newark
Here are honest ranges for the Olympia Chimney repairs we do most in Newark:
- Storm collar reset and reseal: $125 to $225
- Olympia chimney cap replacement: $275 to $550, depending on size and material
- Flashing repair or partial replacement: $350 to $750, depending on access and how much needs cutting out
- Mortar repointing around the crown or brick: $400 to $1,200, depending on the square footage
- Full chimney crown rebuild: $900 to $1,800
- Spalling brick repair: $500 to $1,500, depending on how many bricks and how high up
What moves the price: roof pitch, chimney height, whether we need scaffolding or just ladders, and how much damage has been ignored. Water damage compounds. A small flashing leak caught early is a $400 fix. That same leak two winters later is a $3,000 rebuild. Call (848) 331-2638 for a free estimate, and remember: $40 off any repair over $200, and no trip charge inside the county.
Why Newark Homeowners Call Top Hat Chimney for Olympia Chimney Work
Wendell Pike has been doing this since 1999, and he puts his name and license number on every job. Not a franchise. Not a call center. The same man who takes your call may be the one on your roof. Around Newark, from the Ironbound to Forest Hill, that matters. You run into him at the hardware store on Saturday, and he’ll ask how the chimney’s holding up.
We know Olympia Chimney products because we’ve taken them apart and put them back together for years. We also work with DuraFlex, HeatShield, and Gelco, which means when an Olympia part is discontinued or backordered, we can tell you honestly whether another brand does the job better for less. Every repair is backed by our 90-Day Done Right Promise. You get a better price than the national outfits, a better answer than a parts catalog, and a face you’ll see again in town.
FAQs
We’re an independent Olympia Chimney service provider, not an authorized dealer, and most repairs we do won’t void a warranty. The things that void warranties are improper installation or using parts the manufacturer didn’t approve. We handle both issues directly: we use OEM Olympia parts when required and tell you before we touch anything if a repair could affect warranty coverage. You’ll always know before the work starts.
Most cap replacements and storm collar fixes are done in a single visit, typically within a week of your call. Liner repairs that require removing the old liner take longer, usually a day or two on site. We book by the job, not by the hour, and we call if the schedule slips. Call (848) 331-2638 and we’ll give you a real arrival window.
Repair if the liner is intact except for one or two failed connections. Replace if the liner has holes, severe corrosion, or separated seams that extend beyond a small section. We’ll show you the camera footage and give you a plain-English verdict. If it needs doing, we’ll do it. If it doesn’t, Wendell will tell you that instead.
Every Olympia Chimney repair we do includes a camera inspection before and after the work, new fasteners and sealant where needed, drop cloth protection inside your home, and cleanup before we leave. You get a written copy of the 90-Day Done Right Promise and the camera footage to keep.
We do. We repair and install products from DuraFlex, HeatShield, and Gelco as well. That’s a real advantage when an Olympia part is unavailable or when another brand’s component is simply the better fit for a Newark chimney. We’ll tell you honestly which is which.
If you own an Olympia Chimney product in Newark and something isn’t right, call us at (848) 331-2638. You’ll get a live person, an honest answer, and a free estimate. Wendell and his crew have been fixing chimneys in this city long enough to know what holds up and what doesn’t.
Written by Wendell Pike, Owner, Top Hat Chimney at Top Hat Chimney, serving Newark and nearby areas.